MACHINE SELEP BRICK

MACHINE SELEP

BRICK

I. MACHINE SPECIFICATIONS

1. Dimensions of machine: 4000x 6000x 15 000

2. Material - Engine: Steel 20 mm

- Funnel: 1.2 mm 37 Iron St.

- Frame: Iron L

3. System: Hamer mill

4. Power: 16 Pk

5. Capacity: 2 M 3 / hr

6. Usefulness: Destroyer Red Brick, Tile, Wall to certain Mass. ..


:

II HOW TO OPERATION.

Prepare the way Stater Diesel Engine for 2 minutes
Prepare materials that will be on the road selep drizzle of water to the material that aims to avoid the dust (More Wet Better)
Enter the material slowly from the funnel top and kemidian mill material will come out through a funnel above where one operator was on the machine to enter the material.
If the results are not like that at ingikkan can change the filter.
Where on this machine we will get the same results as the sand.
III HOW OVERCOMING BOTTLENECKS IN MACHINE

If the machine does not spin that in caused by banyakknya material into the mill space is done as follows:

1. Turn off the diesel engine as soon as possible

2. Open the upper funnel by opening the bolt bolt fastener.

3. Discard selutruh materials so that the machine was free of the burden.

4. Close the mouthpiece of the road tighten the bolts fastening bolts.

5. Turn on the engine and operate the machine as before.

IV HOW TO TREATMENT MACHINE.

For this type of machine there is no standard treatment only on the machine just like pengeraknya

- Diesel Oil Do not get exhausted. (100 Hours)

- Do not let the water run out of diesel (all times)

- Always give Lubrication on the Laker / bearings ..

V. OPERATOR SAFETY.

For operator safety are suggested to

1. Wearing the head and face protection (face helmet and pads)

2. Wearing Masks

3. Wear appropriate gloves Hand